- Brand: GAMA MOTORS
- Product Code: PIK-12-3_10-3
- Availability: Pre-order 30 calendar days
Servo-motor of direct current PIK-12 3/10-3 is intended for mechanisms of drives of giving of metal-cutting machines, industrial robots (manipulators) and other executive bodies in modern systems of automatics, telemechanics, measuring equipment.
The motor is designed in accordance with current standards and meets the requirements and standards of IEC 72-1, IEC 34-1, IEC38, ISO2373.
Servomotor PIK-12 3/10-3 is a DC servo motor with excitation from permanent magnets, which provides high current overload and torque. The shaft of the PIK-12 3/10-3 servomotor is made of stainless steel and fixed in precision ball bearings. Thermal insulation class F, operating mode S1.
The modern design of engine components ensure high dynamic qualities - short acceleration and deceleration time, low vibration and noise, long service life and high reliability.
In the servo motor PIK-12 3/10-3 of mass production the electrographic brushes of the EG-74 brand 6,3х10х13,5 mm are used. It is allowed to replace the brushes of the motor only the same size and brand that is specified by the manufacturer. It is forbidden to replace and adjust the brushes during engine rotation.
The main design elements of the PIK-12 3/10-3 servomotor are: permanent magnet rotor, stator with appropriate winding, electrographic brushes, power supply elements.
During operation, servomotor PIK-12 3/10-3 does not require the constant presence of service personnel. It allows continuous operation for 2500 hours without maintenance, subject to operating conditions. The brushes and brush mechanism must be inspected and inspected in the intervals between these periods. When inspecting the servomotor PIK-12 3/10-3, disconnect it from the power supply.
Operating conditions of the PIK-12 3/10-3 engine:
- Ambient temperature + 5 ° C to + 40 ° C;
- Altitude - up to 1000 m;
- Relative humidity - up to 80% at 30 ° C;
- Dust content in the workplace - up to 1 mg / m3.
At the request of the client, the motor can be made with two working ends of the shaft, their sizes may differ from the standard version.
There are no reviews for this product.